Clay sand processing equipment

En877 Cast Iron Fitting

Sml Cast Iron Fitting After cooling, the sand mold is shaken by the vibratory shaker, and the old sand is dropped onto the belt conveyor. The belt conveyor is unloaded and transported. The belt conveyor has a permanent magnet pulley and a belt permanent magnet separator at the head end. The combination of two types of magnetic separation equipment can complement each other's advantages to effectively remove the metal substances in the old sand.

After being unloaded by the belt conveyor, the sand enters the fine hexagonal screen (high-strength stainless steel screen), which is crushed, sieved and cooled. The fine hexagonal crushing screen has a large air extraction port. At this time, the sand has a low water content and a lot of dust Was pumped away. After sieving, the coarse and qualified sand falls into the transition hopper, and the sieves enter the waste hopper and are discharged to the waste sand hopper on the ground through the chute to be treated; the qualified sand is quantitatively transported into the boiling cooling bed by the belt conveyor below the transition hopper , The high-speed uniform air flow from the bottom of the boiling orifice on the boiling cooling bed makes the sand entering the boiling cooling bed fluidized, suspended and boiled, and is drawn through the dust collector to take away the moisture and a lot of heat in the sand .Drainage System Fitting